gratishawk
Alpha
Anyone know what screw size is needed to install a Holosun EPS onto the AOS Prodigy plate
Screw size for the Holosun 507k AOS plate for the Prodigy
- Thread starter gratishawk
- Start date
Net Engineer
Master Class
For that optic it’s Listed in the specs as M3-0.5x10mm, if the plate requires a different size it should have shipped with them or the plate manufacturer should offer a replacement screw kit if you misplaced them.
Word of advice though, if possible use hardened steel screws when using an adapter plate. I had a screw from C&H shear off at the slide due to recoil after putting on one of their plates, had to have it re-tapped and during that process the other one sheared.
Word of advice though, if possible use hardened steel screws when using an adapter plate. I had a screw from C&H shear off at the slide due to recoil after putting on one of their plates, had to have it re-tapped and during that process the other one sheared.
Bragah
Elite
You might want to contact Holosun and see if they'll send you the right screws for it.
I purchased a Vortex Viper and the screws that came with it were too long; called them up and they sent me the right ones free of charge.