testtest

Trouble shooting Hellcat

N

NorthernMN

Alpha
Recently purchased a Hellcat OSP in FDE. Took it to the range and put about 200 rds through it and noticed my accuracy wasn’t great, shots were left on everything. Finished the session with my XDM Elite to get some confidence back. What am I doing wrong?
 
NorthernMN said:
2-3 inches left of center probably shooting at 15-20’
Click to expand...
If it's just shooting left a little bit it could be more time needed with the pistol as others have previously stated and if that doesn't work you could always check to see if the rear sight is slightly out of alignment. The striker block is located under the rear sight of the M&P so that's why the sight was removed.

I have an M&P full-size 9mm that was shooting off a little bit at 30-50 feet after an Apex trigger was installed because the rear sight wasn't set right after removal. It's since been adjusted and now it's fine.
 
NorthernMN said:
2-3 inches left of center probably shooting at 15-20’
Click to expand...

You might want to try changing your finger position on the trigger. Normally I just use my tip of my pad but that did not work with the Hellcat. Using more finger and a change of my grip solved the problem. Then all I had to do was practice, practice, practice drawing with the new grip and finger position.

I hope this helps.
 
You must log in or register to reply here.
Back
Top