xdman

Best source to send an XDM elite slide and a SA-35 slide to for sight installations?

hi, i was told perhaps you could help me with the diameter on the gas block for saint Vic 16" free float 5.56

I have an older (2009) 1911 45 acp micro compact that shoots very low and to the left. half of the front sight is above the rear sight box to be on target. The pic attached shows the slide to barrel geometry pointing the barrel down. Is there a taller rear sight to correct this? What is the dovetail cut called for this pistol? Any ideas?

It was suggested that I contact you directly with this question. Thanks in advance if you can help.

I am having a difficult time removing the standard iron sights on a new Edge AR15 I received. Neither the 5/64 (too small) or the 3/32 (too big) that I have fit hex bolt holding it on. I need to remove the iron sight to get the correct eye relieve for an optic I am mounting. I don't want to strip the bolt.

KLGunner suggested I reach out to you with the following problem previously posted on The Lounge.

Does anyone know where I can obtain trigger pins and screws for the Saint Edge? I tried to go directly to the factory but was told they "are not selling/sending any of the parts for the Saint models. We are strictly using those parts for production during this time."

What size must pictures be to post??
Mine taken from smart phone appear to be too large.

Are you "THE" XDMan that runs the XDMan YouTube channel? If so, thanks for the past knowledge. Enjoy your stuff.