AR308 ejector
- Thread starter SA Dan
- Start date
TEXASforLIFE
SAINT
if it's like or compatible with dpms then yes. do you still have the roll pin and spring?
powerboatr
Professional
ouch
i lost a 12 ga spring in the woods one night, zipppp its gone
hope you find it or locate a new one easy
TEXASforLIFE
SAINT
the ar15 small parts are shared with the ar10's (ejector, ejector spring, safety detent and springs, takedown/pivot springs and detents, buffer springs and keeper). extractors are different though.
Bassbob
Emissary
You didn’t need Springfield to get that part. Or most any part from any AR-15/ AR-10.
TEXASforLIFE
SAINT
SA doesn't sell small parts
Bassbob: I should have mentioned I couldn't find ANY AR ejectors, not just SA. I'm a gunsmith; I've purchased quite a few parts over the years. I have never been able to get a SA-brand part (as stated by TEXASforLIFE, they don't sell them, but you sometimes can beg a service representative and get a part). The few typical parts sellers that I use, and others I looked at, either didn't sell an AR ejector or didn't have one in stock; I was very surprised.
So, maybe you can clue me in on where I might purchase one.
But, thanks for your input.
BTW, I LOVE SA guns.
One other thing: I've found that SA parts are not necessarily what other (DPMS, spec, standard, etc) ARs have. I don't know about the ejector; never needed one, for any brand gun, before.
HansGruber
Ronin
Home
DetailsThe JP Enhanced .308 Extractor has been engineered to provide a much longer service life than standard extractors. Easily swappable in any DPMS pattern bolt to eliminate extraction problems, premature extractor failure and other malfunctions resulting from the extractor not clearing the...
www.primaryarms.com
HansGruber
Ronin
SA is KAC/DPMS pattern, so…
Just Google .308 AR ejector…anything besides Armalite pattern will do.
Bassbob
Emissary
I'd drop this puppy in there.
wilsoncombat.com
BOLT CARRIER ASSEMBLY, AR-10 (DPMS), .308 WINCHESTER, AUTO, DUAL EJECTOR, NICKEL BORON
The nickel boron dual ejector Wilson Combat Bolt Carrier Assembly for .308 Winchester is the perfect solution for any shooter who needs rugged dependability in their rifle.
wilsoncombat.com
HansGruber
Ronin
Bassbob
Emissary
I question whether the bolt is DPMS. I purchased/tried a Wilson (improved) firing pin, which is DPMS; doesn't fit.
I've googled the snot out of it. Found a JP ejector, but doubt that it will work (have a question in to JP tech service).
Also asked SA tech service about it and how to get a replacement; no response so far.
Ha... I hope to never take the little bee-otch out again (reduce probability of losing again), but I also hope to never get another headache.
Also, I don't want to buy another BCG just to get an ejector!
I've googled the snot out of it. Found a JP ejector, but doubt that it will work (have a question in to JP tech service).
Also asked SA tech service about it and how to get a replacement; no response so far.
Ha... I hope to never take the little bee-otch out again (reduce probability of losing again), but I also hope to never get another headache.
Also, I don't want to buy another BCG just to get an ejector!
