testtest

Rear Site is way off center.

ifithitu

ifithitu

Master Class
I don't know how this happen,I haven fired this S&W 40VE in a few years I never notice the rear site being this far of center.Here is a couple of picture of the pistol. You may have to enlarge the picture to really see how far the rear site is off center.
 

Attachments

  • 176472049_3905998379478875_3580895911464054450_n.jpg
    176472049_3905998379478875_3580895911464054450_n.jpg
    19.4 KB · Views: 187
  • 175365693_3905998332812213_6416822460532960259_n.jpg
    175365693_3905998332812213_6416822460532960259_n.jpg
    18 KB · Views: 194
Take a polymer/delrin punch and tap it over. You can tap it all the way out the goob some red locktite in the dovetail. Tap thesight back in, center and clean it up And call it a day. Warning do not remove the front if it is one of the older versions with the melted in place front sight. It will have to go back to SW for a factory install.
 
xdman said:
Take a polymer/delrin punch and tap it over. You can tap it all the way out the goob some red locktite in the dovetail. Tap thesight back in, center and clean it up And call it a day. Warning do not remove the front if it is one of the older versions with the melted in place front sight. It will have to go back to SW for a factory install.
Click to expand...
Thank you for the info.,xdman!(y)
 
Annihilator said:
Didn’t know the early ones had the front site melted in like that, thanks for the info, good to know.
Click to expand...
Oh yea they insert the front sight in the top like a glock front, but then use a sonic tool to melt the base on the inside were the screw would go on a Glock. But they changed so long ago no one has replacements anymore except SW. They will not sell you one, you have to send the slide in and they charge you 50 bucks. We had to do that for a couple local customers.
 
You must log in or register to reply here.
Back
Top