thejunqman
Alpha
I see that the 6" 10mm TRP Operator now can be had with the RMR sight milled into the slide, but it does not have the tactical accessory rail on the lower. Does this combination exist? Thanks.
TRP with RMR and tactical lower rail
- Thread starter thejunqman
- Start date
TEXASforLIFE
SAINT
I don't see 1 on the new models, but you could remove the rear sight and add a rmr mounting plate?
I’d have to search through the forum but someone posted a part number for one on here a while back. Although I’m not 100% sure if it was 10mm, 9mm or .45 ACP. When I find it I’ll tag you in the post.
thejunqman
Alpha
I sent an email to the factory, and they said the combo I asked about is not available.
TEXASforLIFE
SAINT
That would make it too easy! Are you wanting too have a rear sight and a rmr mounted for both to use?
thejunqman
Alpha
Yes, co-witness like the factory RMR set-up. I could have the slide milled (so the red dot sits lower) and get the higher sights.
TEXASforLIFE
SAINT
Between the rear sight and the back of barrel it doesn't look too be enough room? Another note I don't own any 1911s.
TEXASforLIFE
SAINT
At least the adjustable sight 1 looks too be short on space?
Sounds like you may want to contact Springfield Custom Shop then.
thejunqman
Alpha
Custom shop said no. I have a local smith who is going to mill and mount the Trijicon RMR and the higher sights on the TRP Operator. I will post pics when it is all done.
Can’t wait to see it.
PunchySunshine
Elite
Any luck on this mod yet?