testtest

Victor 9mm carbine

lwem200r said:
How much of the thread is protruding past the handguard on the 9mm?

I'm getting ready to install a Kaw Valley ASR Muzzle brake and not sure if I will need a barrel extension.
Click to expand...
You should be fine. Shoulder is right at edge of handguard. If you zoom in on my pick you can see my crush washer on the shoulder.
 

Attachments

  • IMG_0036.jpeg
    IMG_0036.jpeg
    126.2 KB · Views: 62
lwem200r said:
Thank you for this. The blast diverter is a little misleading. It must go over the shoulder a bit.
Click to expand...
Yes very misleading. The barrel goes very deep into the blast diverter. WITH THE FIREARM CLEAR! you can look into the diverter with a light and see the muzzle end. I was actually very surprised how small the actual blast chamber is.
 
lwem200r said:
How much of the thread is protruding past the handguard on the 9mm?

I'm getting ready to install a Kaw Valley ASR Muzzle brake and not sure if I will need a barrel extension.
Click to expand...
The blast diverter is tucked inside handguard.

Why would you need a barrel extension? You're just replacing the blast diverter with a brake.
 
Last edited:
You must log in or register to reply here.
Back
Top