EL LOBO
Custom
I have been reloading now since I was 16 years old, which means I have been doing it now for a total of 51 years. I started with my Stepfather and then some High school friends and even a couple State Policemen Fire Arms Instructor friends and Army Friends I have had through the years, which means I have done just about everything to clean brass. I started with a bucket and Dawn dish soap and shaking, anything I could do to get the hot water and dish soap to clean the brass. Then I discovered the dry media tumble, life was good or so I thought. About 8 to 10 years ago I got a new at the time, Hornady sonic cleaner and dry tumble was out the window! Then I got another model Hornady sonic cleaner with a built-in heater and a much longer timer! To me this was it; I knew I have crossed over into the shiny brass bridge! I didn’t even mind turning each piece of brass over on a metal rack so I could put them in the oven on low to dry for 30 minutes or so. But then one day I tried just taking them from the cleaner to rinse under hot water to a towel. Towel dried but some of the insides are still not cleaned great.I take the towel and put the brass in the middle, fold the towel over and let the brass sag a little and roll the edges up and work the towel back and forth to shake and roll and tumble the water out of the cases. After a couple minutes, I dump the brass into another towel that is dry and do it for about 3 to five minutes and the brass is dry and ready to use! I was satisfied until a friend of mine comes over to give me some 9mm and 45acp he cleaned. It looked like a brand new brass, in fact, This brass was also de primed and resized but the inside of each case looked like it has never had powder in it and It looked like he was giving me new brass. Well, I was wrong, he said he tumbled it. I tumbled brass for years and it NEVER looked like new inside and out! Current brass cleaner I have and use with 5 pounds of stainless steel media He then said, “Wet Tumble” and do it with stainless steel pins. He bought a brand new wet tumbler and as great friends do, he passed his older model to me, stainless media and all. So now I will say there is NO BETTER WAY TO CLEAN ANY USED BRASS, even the old black looking found lying in the wet grass at the range the WET TUMBLE with stainless media! I am using hot water with a little of the Hornady sonic cleaner fluid for now because I have some left, but you can use hot water and a little Simple Green or Purple Power. It's hard to see but the inside of my 223 brass is just as clean as the outside with the wet tumbler! Get one, and if you are just starting out in reloading, don’t waste time and money on dry tumbler or sonic cleaner unless you want to sonic clean gun parts. Get a wet tumbler with stainless media first and be done with it here is a link to Amazon with some of the wet tumblers they sell:
https://www.amazon.com/s/ref=nb_sb_...x=Reloading+Wet+tu,aps,175&crid=2JBGYY4U3OHCT
https://www.amazon.com/s/ref=nb_sb_...x=Reloading+Wet+tu,aps,175&crid=2JBGYY4U3OHCT
